● 7 - 2
This section describes how to activate the setup mode.
1. Turn the power On. Then the scanner displays “Scanner Ready” on the LCD.
Screen M1
2. If the scanner does not have a video interface option, go to the procedure step 3.
Press then the scanner with the video interface option displays Screen M2.
Screen M2
3. Press then the scanner displays Screen M3.
Screen M3
4. Press then the scanner displays Screen M4.
Screen M4
5. Press . Now the scanner is at Screen 1 (page 7-5) in Setup mode.
NOTICE
Any time you press , you can return to the “Scanner Ready” screen.
Rea d
y
XXXXX0
XXX
X
>
Rea d
i
n
gMode
Mo d e
S
e
lect 0
M
Ma n u
a
l
Feed?
Mo d e
S
e
lect 1
=No/ Y
e
s
M
01 Ma
n
u
al Feed
Activating the Setup Mode
To Next Page
Loading...
