● 4 - 4
In this mode, the scanner waits for some predetermined time before issuing a “Paper Empty” message
after all documents are read. This predetermined time (time-out limit) is specified in the Setup mode.
Therefore, you can set the next documents on the ADF paper chute without interrupting the reading
operation.
The procedures for setting the manual feed mode are as follows:
1. Turn the power On and verify that “Scanner Ready” is displayed on the LCD.
Screen M1
2. Press then the scanner displays Screen M2.
Screen M2
3. Press then the scanner displays Screen M3
Screen M3
.
4. Press then the scanner displays Screen M4.
Screen M4
5. Select “Yes” by pressing . Then press .
6. Press to return to the “Scanner Ready” screen. Note that “Manual Feed” is shown on the LCD.
This means that the scanner is in Manual Feed mode.
Screen M1
Rea d
y
XXXXX0
XXX
X
>
Rea d
i
n
gMode
M ode
S
e
l e ct 0
M
Ma n u
a
l
Feed?
Mo d e
S
e
lect 1
=No/ Y
e
s
M
01 Ma
n
u
al Feed
Rea d
y
XXXXX0
Ma n u
a
l
XXX
X
>
Manual Feed Mode Setting
To Next Page
Loading...
Need help?
General
