AP-15
APPENDIX-3 TROUBLESHOOTING
Should any of the following problems arise, refer to the relevant section listed below.
Scanner cannot be turned on.
Refer to Chapter 5.2 Troubleshooting “Symptom1” of the fi-4860C2 Operator’s Guide.
The operator panel LCD goes out.
Refer to Chapter 5.2 Troubleshooting “Symptom2” of the fi-4860C2 Operator’s Guide.
Scanning does not start.
Refer to Chapter 5.2 Troubleshooting “Symptom3” of the fi-4860C2 Operator’s Guide.
Quality of scanned pictures and photographs is not satisfactory.
Refer to Chapter 5.2 Troubleshooting “Symptom4” of the fi-4860C2 Operator’s Guide.
Quality of scanned text or lines is unsatisfactory.
Refer to Chapter 5.2 Troubleshooting “Symptom5” of the fi-4860C2 Operator’s Guide.
The scanned image is distorted and/or not sharp.
Refer to Chapter 5.2 Troubleshooting “Symptom6” of the fi-4860C2 Operator’s Guide.
Vertical streaks appear in the scanned image.
Refer to Chapter 5.2 Troubleshooting “Symptom7” of the fi-4860C2 Operator’s Guide.
Check LED starts blinking right after power on.
Refer to Chapter 5.2 Troubleshooting “Symptom8” of the fi-4860C2 Operator’s Guide.
The Check LED lights right after power on.
Refer to Chapter 5.2 Troubleshooting “Symptom9” of the fi-4860C2 Operator’s Guide.
Double-feed occurs frequently.
Refer to Chapter 5.2 Troubleshooting “Symptom10” of the fi-4860C2 Operator’s Guide.
Document jam occurs frequently.
Refer to Chapter 5.2 Troubleshooting “Symptom11” of the fi-4860C2 Operator’s Guide.
There is a shadow on the leading edge of the scanned image.
Refer to Chapter 5.2 Troubleshooting “Symptom12” of the fi-4860C2 Operator’s Guide.
Scanner is not recognized by PC automatically.
Refer to Chapter 5.2 Troubleshooting “Symptom13” of the fi-4860C2 Operator’s Guide.
Windows
®
system gets unstable.
Refer to Chapter 5.2 Troubleshooting “Symptom14” of the fi-4860C2 Operator’s Guide.
To Next Page
Loading...
