3. Select [Auto Color Detection] under [Output mode].
4. Under [Select Current Image Setting], select a side, and then configure settings for each side in
the [TWAIN Driver] dialog box.
You need to configure both of the settings for [Color/Grayscale] detection and for [Binary] detection in advance.
5. In the [TWAIN Driver] dialog box, click the [OK] button.
Changes made are saved and the [TWAIN Driver] dialog box closes.
Continue scanning in ScandAll PRO.
For information about how to scan documents, see Section "
2.6 How to Use ScandAll PRO."
All Rights Reserved. Copyright 2007-2008 © PFU LIMITED
file:////10.232.227.50/Manual/fi-6140_6240C-Lynx3/OG/R02/02_081030/contents/EN/03/c03_12_01.htm (2/2) [2008/10/30 12:42:11]
To Next Page
Loading...
