fi-6140 / fi-6240 Image Scanner Operator's Guide
TROUBLESHOOTING
CONTENTS MAP
TOP
8.4 Multifeed Detection
"Multifeed" is a feeding error that occurs when two or more sheets in the ADF paper chute are fed simultaneously into
the scanner.
If you continue scanning document without knowing this multifeed error, you could skip some of important data
while scanning the document.
The Multifeed Detection function this scanner provides can prevent such troubles.
With the Multifeed Detection, the scanner indicates a message and halts the scanning immediately when a multifeed
is detected.
(Note that the Multifeed Detection is not available for the range about 30 mm from the leading edge of document.)
Configure the settings for the Multifeed Detection as follows.
1. Start up the Software Operation Panel.
See Section "8.1 Scanner Settings."
2. Select [Device Setting 2] from the left side list in the window, and select [Multifeed] from its lower
level.
file:////10.232.227.50/Manual/fi-6140_6240C-Lynx3/OG/R02/02_081030/contents/EN/08/c08_04_01.htm (1/5) [2008/10/30 12:42:44]
To Next Page
Loading...
