fi-6140 / fi-6240 Image Scanner Operator's Guide
TROUBLESHOOTING
CONTENTS MAP
TOP
8.5 Page Edge Filler
Depending on the state of the documents, the shadow of the scanned document appears in the end portion of the
output image and black thin lines may be generated.
If this is the case, you can improve the output image by using the “Page Edge Filler” function. This function fills the
end portion of the image so that it looks clean.
Configure the settings for the Page Edge Filler as follows:
1. Start up the Software Operation Panel.
See Section "8.1 Scanner Settings."
2. Select [Device Setting 2] from left side list in the window, and select [Paper Edge Filler (ADF)] or
[Paper Edge Filler (FB)] from its lower level.
3. Specify the length for each end section; top, bottom, right, and left, to fill the end sections.
file:////10.232.227.50/Manual/fi-6140_6240C-Lynx3/OG/R02/02_081030/contents/EN/08/c08_05_01.htm (1/2) [2008/10/30 12:42:45]
To Next Page
Loading...
