1. Create a new batch profile on ScandAll PRO, and open the [Profile Editor] window.
For how to create a profile, see "Batch Scan" in Section "2.6 How to Use ScandAll PRO."
2. Click on the [Document separator] tab.
3. Mark the [Use Barcode-Based Job Separation Sheet] checkbox.
HINT
● To suppress scanning the patch code sheet images, check the [Remove separation
sheet] checkbox.
● In duplex scan mode, you can disable scanning of the rear side of the patch code
sheet by selecting the [Delete the next page of a separation sheet] checkbox.
4. Click the [Setup] button.
The [Barcode Setting] dialog box appears.
file:////10.232.227.50/Manual/fi-6140_6240C-Lynx3/OG/R02/02_081030/contents/EN/03/c03_17_01.htm (2/5) [2008/10/30 12:42:21]
To Next Page
Loading...
