fi-6140 / fi-6240 Image Scanner Operator's Guide
TROUBLESHOOTING
CONTENTS MAP
TOP
6.3 Remedying Typical Troubles
Symptom: The scanning does not start.
Back
Did you unlock the transport lock of the
Flatbed? (fi-6240 only)
NO
Turn OFF the scanner and unlock the transport
lock.
(Refer to "2.1 Installing the Scanner in "fi-
6140/fi-6240 Getting Started.")
YES
Are the document loaded correctly on the ADF
paper chute?
NO
Load the document correctly on ADF paper
chute.
YES
Is the ADF closed completely?
NO
Remove the document in the ADF paper chute,
open the ADF, and then close it completely.
YES
Is the interface cable connected correctly?
NO
Connect the interface cable correctly.
(Refer to "2.2 Connecting the Scanner to Your
PC" in "fi-6140/fi-6240 Getting Started.")
YES
Is the connector of interface cable broken?
YES
Use a new interface cable and correctly
connect it.
NO
(When using scanner on SCSI interface)
Is the SCSI ID set correctly?
NO
Turn OFF the scanner and set the SCSI ID
correctly, then turn ON the scanner again.
(Refer to "2.2 Connecting the Scanner to Your
PC" in "fi-6140/fi-6240 Getting Started.")
YES
file:////10.232.227.50/Manual/fi-6140_6240C-Lynx3/OG/R02/02_081030/contents/EN/06/c06_03/03.htm (1/2) [2008/10/30 12:41:01]
To Next Page
Loading...
