Getting started
Vertical operating position
VerticaloperatingpositionOperatingposition, verticalBasefeetSidecover
If you wish to operate the device in the vertical operating position, use
the tw o feet supplied for vertical o peration.
Only mount the feet on the device side shown in the diagrams.
If connecting man y cables to the device, ensure that the device is in a stable
position, in order to prevent it from toppling over.
Proceed as follows to prepare the device for the vertical operating position:
► Disconnect the cables if required.
► Laythedeviceonitstop(
narrow side) as shown, on a stable, flat and clean surface.
1
3
3
3
3
1
2
► Place the feet on the casing (1). In doing so, make sure that the 4 clips (2) on the
feet are aligned above the corresponding holes in the casing.
► To secure the feet, press the clips in the direction of the arrow (2) until
they are felt to engage in the holes.
Fujitsu 15
To Next Page
Loading...
