Operation
Switching off the device
► Shut dow n the operating system in the proper way. In Windows: from the
Start menu select the Shut Down option.
Device,Monitor,
► If the operating system does not automatically switch the device into energy-saving mode or
switch it off, press the ON/OFF switch. Warning, this could lead to a loss of data!
If the device is switched off, it consumes a minimum of energy.
The ON/OFF switch does not disconnect the device from the mains voltage. To
completely disconnect the mains voltage, remove the power plug from the power socket.
► If necessary, switch the monitor off (see the operating manual for the monitor).
Activating power-saving mode
Due to custo mer requirements and requirements of the operating system, the
"Wake-on-LAN" (WoL) function is switched on by default. With the WoL function,
the power draw in O FF mode increases slightly.
To meet the req uirements of EC regulation 1275/2008 regarding the implementation of the
Ecodesign directive (2009/125/EC), the default WoL setting must be changed as follows:
► To start the BIOS Setup utility after the system start, press the ON/OFF
switch for two to three seconds.
or
► Press the
F2
function key.
► In the Power su b-menu, change the External Power Button Control, LAN and Keyboard to disabled.
► To save the setting and exit the BIOS Se tu p Utility, press funct ion key
F4
.
After making this change, the system will achieve the lowest energy
saving mode during shut-down.
In this status, the “Wake-on-LAN” function can no longer be used.
Open BIOS Setup
BIOS-Se
tup
► When the system starts, press the ON/OFF switch for two to three seconds.
or
► Press (possibly several times) the
F2
key.
BIOS Se
tup will be started. Select one of the tabs to access other setting options in BIOS Setup.
PXE system boot
PXEsystem boot
► Switch the device on with the ON/OFF switch.
► When
starting the system, press the
F12
key several times.
The boot menu is displayed.
► Sel
ect the desired boot option.
26 Fujitsu
To Next Page
Loading...
