Getting started
Connecting external devices
Read the documentation on the external device before connecting it.
With the exception of USB devices, always remove all power plugs
before connecting external d evices!
Do not connect or disconnect cables during a thunderstorm.
Always hold the plug of a cable when removing it. Never unplug a
cable by pulling the cable itself.
To ensure that your device works properly, use only the connection cable
supplied or use a high-quality connection cable.
Ports on the device
PortsExternaldevicesDevice
The ports are located on the front and re ar of the device. The ports available on
your device depend on the configuration level you have selected. The standard ports
are marked with the symbols shown below (or similar).
Headphone port, black (front
of device)
HeadphoneportHeadphones
Microphone port, black (front of device)
Microphonepo rtMicrophone
RJ45-LAN port
LANport
Serial port
Serialport
USB 3.1 - Universal Serial
Bus, Gen 1 Type-A: blue,
Gen1 type-C: black
UniversalSe
rialBus
DP DisplayPort
USB 2.0 - Universal Serial
Bus, type-A: black
Audio output (Line Out), black
AudiooutputLineout
Some of the connected devices require special software (e.g. drivers) (refer to the
documentation for the connected device and operating system).
Connecting a monitor
Only attach the screen to your device w hen it is switched off.
► Follow the instructions contained in th e monitor manual to prepare the monitor
for operation (e.g. connecting c ables).
Monitor,
► Connect the data cable to the required monitor port on your device.
► Plug the monitor power cable into the grounded mains outlet.
Fujitsu 19
To Next Page
Loading...
