Fujitsu Inverter - Cleaning the Intake Grille; Cleaning the Air Filter

En-14
Cleaning the Intake Grille
1. Remove the Intake Grille.
1
Place your fi ngers at both top indicator of the grille pan-
el, and pull forward; if the grille seems to catch partway
through its movement, continue pulling down to remove.
2
Unhook the ropes which holds the grille.
2. Clean with water.
Remove dust with a vacuum cleaner; wipe the unit with
warm water, then dry with a clean, soft cloth.
3. Replace the Intake Grille.
1
Hook the ropes.
2
Set the left and right mounting shafts into the bearings
at the bottom of the panel.
3
Press the place where the mark on the diagram indi-
cates and close the Intake Grille.
Cleaning the Air Filter
1. Open the Intake Grille, and remove the
air fi lter.
Push down the air fi lter’s handle, disconnect the 2 upper
tabs, and pull out.
2. Remove dust with a vacuum cleaner or
by washing.
After washing, allow to dry thoroughly in a shaded place.
3. Replace the Air Filter and close the In-
take Grille.
1
Align the sides of the air fi lter with the panel, and push
in fully, making sure the 2 upper tabs are returned prop-
erly to their holes in the panel.
2
Close the Intake Grille.
●
Dust can be cleaned from the air fi lter either with a vacuum
cleaner, or by washing the fi lter in a solution of mild deter-
gent and warm water. If you wash the fi lter, be sure to allow
it to dry thoroughly in a shady place before reinstalling.
●
If dirt is allowed to accumulate on the air fi lter, airfl ow will be
reduced, lowering operating effi ciency and increasing noise.
●
During periods of normal use, the Air Filters should be
cleaned every 2 weeks.
Intake
Grille
3
2
1
2
1
3
Rope
1
1
2
2
Intake
Grille
Rope
PANEL
AIR FILTER
AIR FILTER
PANEL
9378532038-03_OM.indb 149378532038-03_OM.indb 14 2/25/2013 3:46:32 PM2/25/2013 3:46:32 PM