65
- Memory Upgrade Module
Removing a Memory Module
Installing a Memory Module
1 Align the connector edge of the memory upgrade module, chip side up, with the connector slot in the
compartment.
(Figure 25)
2 Insert the memory upgrade module at a 45
o
angle and press it firmly onto the connector.
3 Press the memory upgrade module down into the compartment until it locks underneath the retaining clip. You
will hear a click when it is properly in place.
4 Replace the memory compartment cover. (Figure 26)
1 Perform steps 1 through 3 of Accessing the
Memory Compartment.
2 Pull the module clips sideways away from each
side of the memory module simultaneously.
(Figure )
3 While holding the clips out, remove the module
from the slot by lifting it up and pulling towards the
back of your LIFEBOOK notebook.
4 Store the memory upgrade module in a static
guarded sleeve.
5 Install a new memory module as detailed in the
procedure below.
6 Replace the memory compartment cover.
(Figure 26)
Figure 24. Removing a memory module
To Next Page
Loading...
