73
- Device Ports
2 Push the connector into the port until it is seated.
External Video Port
IF YOU PLUG HEADPHONES INTO THE HEADPHONE JACK, THE BUILT-IN STEREO SPEAKERS WILL BE DISABLED.
The external video port allows you to connect an
external monitor or LCD projector. In order to
connect an external device follow these easy steps:.
There is also an external VGA monitor port on the
port replicator (Figure 34).
1 Align the connector with the port opening.
2 Push the connector into the port until it is
seated.
3 Tighten the two hold-down screws, located on
each side of the connector.
Figure 33. Connecting an External Video Device
WHEN AN EXTERNAL MONITOR IS PLUGGED IN, PRESSING THE [FN] + [F10] KEYS ALLOWS YOU TO CHANGE YOUR SELECTION OF WHERE TO SEND
YOUR DISPLAY VIDEO. EACH TIME YOU PRESS THE KEY COMBINATION, YOU WILL STEP TO THE NEXT CHOICE. THE CHOICES, IN ORDER, ARE: BUILT-IN
DISPLAY PANEL ONLY, EXTERNAL MONITOR ONLY, BOTH BUILT-IN DISPLAY PANEL AND EXTERNAL MONITOR, DISPLAYPORT, AND BOTH LCD AND
D
ISPLAYPORT. NOTE THAT DEPENDING UPON SYSTEM CONFIGURATION, ALL OF THESE STEPS MAY NOT BE AVAILABLE.
To Next Page
Loading...
