Fujitsu MHV2100AH - Page 21

Contents
C141-E217 xvii
Figure 5.2 Execution example of READ MULTIPLE command...................... 5-63
Figure 5.3 READ SECTOR(S) COMMAND protocol................................... 5-130
Figure 5.4 Protocol for command abort.......................................................... 5-131
Figure 5.5 WRITE SECTOR(S) command protocol....................................... 5-133
Figure 5.6 Protocol for the command execution without data
transfer ....................................................................................... 5-135
Figure 5.7 Normal DMA data transfer............................................................ 5-136
Figure 5.8 Ultra DMA termination with pull-up or pull-down........................ 5-148
Figure 5.9 PIO data transfer timing................................................................ 5-149
Figure 5.10 Multiword DMA data transfer timing (mode 2)........................... 5-150
Figure 5.11 Initiating an Ultra DMA data in burst.......................................... 5-151
Figure 5.12 Sustained Ultra DMA data in burst ............................................. 5-155
Figure 5.13 Host pausing an Ultra DMA data in burst.................................... 5-156
Figure 5.14 Device terminating an Ultra DMA data in burst .......................... 5-157
Figure 5.15 Host terminating an Ultra DMA data in burst.............................. 5-158
Figure 5.16 Initiating an Ultra DMA data out burst........................................ 5-159
Figure 5.17 Sustained Ultra DMA data out burst............................................ 5-160
Figure 5.18 Device pausing an Ultra DMA data out burst .............................. 5-161
Figure 5.19 Host terminating an Ultra DMA data out burst............................ 5-162
Figure 5.20 Device terminating an Ultra DMA data out burst ........................ 5-163
Figure 5.21 Power-on reset timing................................................................. 5-164
Figure 6.1 Response to power-on....................................................................... 6-3
Figure 6.2 Response to hardware reset............................................................... 6-4
Figure 6.3 Response to software reset................................................................ 6-5
Figure 6.4 Response to diagnostic command...................................................... 6-6
Figure 6.5 Sector slip processing ..................................................................... 6-10
Figure 6.6 Automatic alternating processing.................................................... 6-11
Figure 6.7 Data buffer structure ....................................................................... 6-12