Fujitsu N7100E - Page 21

21
■ Action
Set the scanner URL as a trusted site for Internet
Explorer.
1. In Internet Explorer, select the [Tools] menu  [Internet
Options].
2. On the [Security] tab, select [Trusted sites] and click the
[Sites] button.
3. Enter the URL of the scanner in the [Add this website to
the zone] field, and click the [Add] button.
■ Action
When connecting using the scanner name, the
connection will be an intranet connection. When
connecting using an IP address, it will be an internet
connection.
Try the following settings for the corresponding zone.
1. In Internet Explorer, select the [Tools] menu  [Internet
Options].
2. Enable [Active scripting] in either of the following ways:
- On the [Security] tab, click the [Default level] button
to set [Security level for this zone] to [Medium].
- On the [Security] tab, c
lick the [Custom level]
button to
set to [Enable] for [Active scripting]
under
[Scripting] in the [Settings] area.
3. If connecting via the Internet zone, on the [Privacy] tab,
set the level to [Medium High] or below.
4. Delete all temporary internet files. For details, refer to
Help for Internet Explorer.
■ Action
Press the power button to start the scanner.
■ Action
Set the proxy server not to be used.
1. In Internet Explorer, select the [Tools] menu  [Internet
Options].
2. Press the [LAN settings] button on the [Connections]
tab.
3. Clear the [Use a proxy server for your LAN (These
settings will not apply to dial-up or VPN connections)]
check box.
■ Action (Scanner)
Check if SSL is enabled on the [Admin Connection]
window.
The [Admin Connection] window can be displayed as
follows:
1. Select [Admin Connection] under [Network Admin].
■ Action (Computer with Internet Explorer, the
Admin Tool, or the User Editor installed)
1. In Internet Explorer, select the [Tools] menu  [Internet
Options].
2. Press the [Advanced] tab.
3. Under [Security] in the [Settings] section, select the
check boxes for the following items. The check boxes to
be selected should be the same as the check boxes that
are selected in the settings on the scanner (check boxes
for [SSL Encryption] in the [Admin Connection] window).
- Use SSL 3.0
- Use TLS 1.0
- Use TLS 1.1
- Use TLS 1.2
■ Action
Check the specified port number on the [Admin
Connection] window.
The [Admin Connection] window can be displayed as
follows:
1. Select [Admin Connection] under [Network Admin].
The URL of the target scanner is not
registered as a trusted site.
In Internet Explorer, the security level for
the target zone is set to [High] on the
[Security] tab in the [Tools] menu -
[Internet Options].
In [Custom Level], [Prompt] or [Disable]
is set for [Active scripting] under
[Scripting] in the [Settings] area.
The scanner is in standby mode.
A proxy server is being used.
There is an error with the connection
protocol setting.
There is an error with the port number
setting.