5.3 Connecting devices to the server
The connectors for external devices are on the front and rear of the server. The
additional connectors available on your server depend on the expansion cards
installed. For further information refer to the "FUJITSU Server PRIMERGY
RX2540 M1 Server Upgrade and Maintenance Manual".
Figure 2: Connection panel on the rear
1 Video connector (blue) 4 2 USB connectors (USB 3.0)
2 Management LAN connector 5 2 USB connectors (USB 2.0)
3 Dynamic LoM (optional, different
variants)*.
6 COM1 connector (optional)**
*
The LAN connectors on the dynamic LoM modules are numbered in
ascending order from right to left beginning with “0”.
The rightmost
connector (LAN 0) is the shared LAN connector respectively.
** The serial interface COM1 can be used as the standard interface or for
communication with iRMC.
To Next Page
Loading...
