TX1310 M1
Operating Manual 41
Hardware installation
5.2 Setting up the server
Ê Transport the server to the place where you want to set it up.
Ê Unpack the server (see section "Unpacking the server" on page 40).
Ê Set up the server.
V CAUTION!
– The device must be protected from direct sunlight.
– The required minimum distances for operation and maintenance
areas must be adhered to.
– The server must be accessible at the rear for connection to other
devices (e.g. memory subsystem).
– The mains plug must be accessible easily and safely.
– There must be a clearance of at least 200 mm in front of and
behind the server to ensure adequate ventilation of the
subsystem.
Ê Wire the server. Follow the instructions in sections "Connecting devices to
the server" on page 42 and "Notes on connecting/disconnecting cables" on
page 45.
Ê Connect the server to the mains (see section "Connecting the server to the
mains" on page 43).
To Next Page
Loading...
Need help?
General