TX1310 M1
Operating Manual 43
Hardware installation
Two additional USB 3.0 connectors are located on the front of the server (see
figure figure 5 on page 48).
Connecting the monitor
Ê Connect the monitor to the video connector of the server (see figure figure 2
on page 42).
Ê Connect the power cable of the monitor to a grounded mains outlet of the in-
house mains.
V CAUTION!
The rated current for the monitor is indicated on the technical data label
on the monitor or in the operating manual for the monitor.
5.4 Connecting the server to the mains
The server is equipped with an integrated power supply unit.
V CAUTION!
The server is automatically set to a mains voltage in the range 100 V -
240 V. You may only operate the server if its rated voltage range
corresponds to the local mains voltage.
Ê Connect the power cord to the server power supply unit.
Ê Connect the mains plug to a grounded mains outlet in the in-house power
supply network.
To Next Page
Loading...
