Fujitsu PRIMERGY TX1310 M1 User Manual

TX1310 M1 Operating Manual 55
Starting up and operation
6.4 Configuring the server
This section contains information about configuring the server and installing the
operating system.
I Make sure that the power saving functions are disabled in the Power
menu of the BIOS Setup during operation.
6.4.1 Configuring the onboard SATA controller
A SATA controller is integrated on the system board. You can configure the
onboard controller either before or during installation with the ServerView
Installation Manager. Using the ServerView Installation Manager is
recommended.
I In the system BIOS the onboard SATA controller can be configured as:
– AHCI mode (default) or
– IDE mode or
– RAID mode.
When selecting "RAID Mode" additional settings are necessary in LSI
Software RAID Configuration Utility. You will find more information about
configuring the SATA Controller in “D3219 BIOS Setup Utility for
FUJITSU Server PRIMERGY TX1310 M1 Reference Manual”.

Fujitsu PRIMERGY TX1310 M1 Specifications

General

Brand	Fujitsu
Model	PRIMERGY TX1310 M1
Category	Server
Language	English