Fujitsu PRIMERGY TX1320 M3 - 6.6 Configuring the Server; Configure Onboard SATA Controller

80 Operating Manual TX1320 M3
Starting up and operation
6.6 Configuring the server
This section contains information about configuring the server and installing the
operating system.
6.6.1 Configuring the onboard SATA controller
A SATA controller is integrated on the system board. You can configure the
onboard controller either before or during installation with the ServerView
Installation Manager. Using the ServerView Installation Manager is
recommended.
I The controller has its own configuration utility. For further information,
refer to the “Embedded MegaRAID Software User’s Guide” (on the
Fujitsu manuals server under x86 Servers - Expansion Cards - Storage
Adapters - LSI Configuration Software).
I Descriptions of operating systems not covered in the controller manual
are provided in the corresponding readme under:
http://www.fujitsu.com/global/services/computing/server/ia/driver/index.html
For Japan:
http://www.fujitsu.com/jp/products/computing/servers/primergy/downloads/