EasyManua.ls Logo

Fujitsu PRIMERGY TX1320 M4 - Setting up the Floorstand Model; Installing the Stabilizers

Fujitsu PRIMERGY TX1320 M4
102 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
TX1320 M4 Operating Manual 59
Starting up
5.3 Setting up the floorstand model
if you are using a PRIMERGY TX1320 M4 server horizontally, skip this section
and continue reading ar section "Positioning the server horizontally" on
page 62.
V CAUTION!
Note the safety instructions in chapter "Important information" on
page 41.
Ê Transport the server to the place where you want to set it up.
Ê Unpack the server (see section"Unpacking the server" on page 58).
Ê Set up the server.
V CAUTION!
The device must be protected from direct sunlight.
The required minimum distances for operation and maintenance
areas must be adhered to.
The server must be accessible at the rear for connection to other
devices (e.g. memory subsystem).
The mains plug must be accessible easily and safely.
There must be a clearance of at least 200 mm in front of and
behind the server to ensure adequate ventilation of the
subsystem.
Ê If applicable, install the stabilizers, see section "Installing the stabilizers" on
page 59.
Ê Connect the devices to the server, see section "Connecting devices to the
server" on page 64 and section "Notes on connecting/disconnecting cables"
on page 63.
Ê Connect the server to the mains, see section"Connecting the power cord" on
page 65.
5.3.1 Installing the stabilizers
V CAUTION!
If the server is positioned vertically, the stabilizers must be attached!
The stabilizers must be attached in the correct direction.

Table of Contents

Other manuals for Fujitsu PRIMERGY TX1320 M4

Related product manuals