Appendix
Appendix
Glossary
Introduction
Index
Contents
148
How to Load
Documents
Scanner
Overview
TOP
How to Use the
Operator Panel
Various Ways to
Scan
Daily Care
Troubleshooting
Replacing the
Consumables
Operational
Settings
*1: Long page scanning supports documents with a length up to 3,048 mm (120 in.).
To scan documents longer than 863 mm (34 in.), set the resolution to 200 dpi or lower.
*2: The paper weight only applies to using the ADF. There is no limitation when using the flatbed.
*3: Note that this is the hardware limitation, and the software's processing time such as data transfer time is added to the actual time of scanning.
*4: The capacity varies depending on the paper weight. For details, refer to "2.3 Documents for Scanning" (page 42).
*5: Use the included USB cable.
When connecting to a USB hub, be sure to use a USB hub that is connected to a USB port on the computer.
Connection with USB 2.0 requires the USB port and the hub to support USB 2.0. Also note that the scanning speed slows down when using USB 1.1.
Connect the USB cable with the USB logo facing up.
Output
resolution
Binary (black & white) 50 to 600 dpi, 1200 dpi 50 to 600 dpi, configurable in 1 dpi
increments
1200 dpi: available from scanner
driver
Grayscale
Color
Grayscale level 8-bit for each color For internal processing, 10-bit for
each color
Interface USB 2.0/1.1 (*5) Type B
Other Hardware real-time JPEG compression -
Item Specification Notes
ScanPartner SP25 ScanPartner SP30 ScanPartner SP30F
To Next Page
Loading...
