Chapter 6 Replacing the Consumables
Appendix
Glossary
Introduction
Index
Contents
TOP
83
How to Load
Documents
How to Use the
Operator Panel
Various Ways to
Scan
Daily Care
Troubleshooting
Operational
Settings
Scanner
Overview
Replacing the
Consumables
6 Attach the shaft.
1 Insert the left side of the shaft into the hole, and then attach the
right side of the shaft.
2 Close the cover.
7 Close the ADF.
For details, refer to "1.4 Opening/Closing the ADF" (page 25).
8 Reset the consumable counter.
Start up the Software Operation Panel and reset the counter.
For details, refer to "Resetting the sheet counters" (page 130).
ATTENTION
Confirm that the brake roller is installed properly. Otherwise, it may
cause feeding errors such as paper jams.
Be careful not to have your fingers caught
when closing the ADF.
To Next Page
Loading...
