CONTENTS
INTRODUCTION
1 NAMES AND FUNCTIONS OF PARTS
2 BASIC SCANNER OPERATIONS
2.1 Turning the scanner ON
2.2 Loading Documents on the ADF for
Scanning
2.3 Scanning Documents
2.4 How to Use the Scanner Driver
3 SCANNING VARIOUS TYPES OF
DOCUMENTS
4 DAILY CARE
5 REPLACING CONSUMABLES
6 TROUBLESHOOTING
7 DOCUMENT SPECIFICATIONS FOR ADF
8 OPTIONS
9 SCANNER SPECIFICATIONS
Appendix
2.4 How to Use the Scanner Driver(16)
10
11 12 13 14 15
16
[More...] button
Opens [More Settings] window. Used for setting advanced features.
DTC Variance
This option specifies the value for adjusting the variance based on the brightness of the
image.
Edge Processing
This option specifies the sharpness of contour extraction.
Low, Mid, High
Emphasizes contour of images. Available
settings are: Low, Mid, High
Smoothing
Smoothes jaggy images.
Dropout Color
This option excludes selected color (the three primary colors of light i.e. green, red, blue)
from scanned images. For example, if the document contains black text in a red frame and
when the red color is selected, the scanner reads only the text and eliminate (drop out) the
red frame.
If you do not wish to have any colors dropped out select "None".
Reverse
Colors of scanned images are reversed.
End of Page Detection
Scans the edge (bottom) of the documents and outputs data adjusted to the document
length. When any page shorter than specified "Paper Size" is included, the output size is
adjusted to the detected short size.
Gamma
Specifies Gamma correction. Correction patterns are: "Normal", "Soft", "Sharp", "Custom", or
"Download".
Multi Feed Detection
Detects multi feeds (phenomena that two or more sheets are accidentally fed). You can set
conditions for detecting multi feeds so that the scanner should stop and display error
messages. Multi feeds are scanned by the differences in document lengths or thicknesses.
10
11 12 13 14 15
16
CONTENTS
To Next Page
Loading...
Need help?
General