CONTENTS
INTRODUCTION
1 NAMES AND FUNCTIONS OF PARTS
2 BASIC SCANNER OPERATIONS
2.1 Turning the scanner ON
2.2 Loading Documents on the ADF for
Scanning
2.3 Scanning Documents
2.4 How to Use the Scanner Driver
3 SCANNING VARIOUS TYPES OF
DOCUMENTS
4 DAILY CARE
5 REPLACING CONSUMABLES
6 TROUBLESHOOTING
7 DOCUMENT SPECIFICATIONS FOR ADF
8 OPTIONS
9 SCANNER SPECIFICATIONS
Appendix
2.2 Loading Documents on the ADF for Scanning
1
2 3 4 5 6
1. Confirm the following items before loading documents.
Confirm that all the documents have the same width.
Check the number of sheets in the document stack.
The standard number of sheets that can be loaded on the scanner is as follows:
❍ A4-size paper or smaller that makes a document stack of 5mm or less
❍ Maximum 50 sheet at A4, 20 lb, or 80 g/m
2
2. Fan the documents as follows:
Lightly grip both ends of the document, then bend and fan it.
Repeat this operation a couple of times.
Rotate the document 90 degrees, then bend and fan it again.
Align the edges of the documents.
1
2 3 4 5 6
CONTENTS
To Next Page
Loading...
Need help?
General