ScanSnap S300 Getting Started 16
• [Set the document face-down and scan (Recommended)]
Select when loading the document face-down and upside-down on the
ScanSnap.
• [Set the document face-up and scan]
Select when loading the document face-up and upside up.
* Note: You can change this setting after installation. This dialog box will not
appear after reinstallation.
See Operator’s Guide section 4.2 on how to "Set the documents with
its face up."
Specify whether to [Notify scanning result] after scanning.
If the check box is marked, a message telling you that the following
functions were performed or not appears.
• Allow automatic blank page removal
• Allow automatic image rotation
* Note: You can change this setting after installation. This dialog box will not
appear after reinstallation.
See Operator’s Guide section 4.1 on how to "Show scanning results."
To Next Page
Loading...
