En-7
TURN ON THE POWER
Turn on the power
Once the installation and wiring has been completed, use the following procedure to turn on the power.
1. Turn on the power for all connected indoor units.
2. Turn on the power for all connected outdoor units.
3. Turn on the power for all connected convertor of group remote controllers.
For J-series
1. Turn on the power for all connected indoor units and outdoor units.
2. Turn on the power for all connected convertor of group remote controllers.
Wait for one minute or more after turning on the power before performing the next section.
SETTINGS
Switching to the Settings Screen
Initial Screen
Flashing
Flashing
1
Settings
Hold down the Set Time buttons and simultaneously for two seconds or more to start the Settings.
2
Press the Set Temperature button to select the item to be set.
Settings
: REMOTE CONTROLLER SETTINGS → Page 8
: INDOOR UNIT REGISTRATION → Page 11
, , , , , : Forbidden 1-6
● To complete Settings
Hold down the Set Time buttons and
simultaneously for two seconds or
more to complete the settings.
NOTES
When there is a display other than the initial screen, it is possible that an error has occurred.
Please consult authorized service personnel in such cases.
(
)
Turn on the power
Error code
(Refer to page 14.)
To Next Page
Loading...
Need help?
General
