Fujitsu UTB-YDB - Indoor Unit Registration; Indoor Unit Registration Methods; Manual Registration

En-11
INDOOR UNIT REGISTRATION
● A maximum of 8 remote controller groups can be registered for a Group remote controller.
● Remote controller groups in 2 different refrigerant systems that are connected to a single convertor can be registered.
● The remote controller groups registered can be monitored and controlled.
● When registering indoor units to each of the buttons, consult the customer.
Indoor unit registration screen
1
2
3
4
Refrigerant circuit address
(Not shown with J-series)
Registration position
Indoor unit address
Remote controller address
(Not shown with J-series)
Indoor Unit Registration Methods
● Manual registration
● Automatic registration (J-series only)
Manual Registration
To register indoor units manually
1
● Registration position selection
Press the Select button to select the position for registering the indoor unit
2
● Refrigerant circuit address selection (Not used for J-series)
Press the DAY button to select the refrigerant circuit address for the indoor unit being registered.
• Hold down a Set Time button to scroll through the addresses quickly.
DAY
3
● Indoor unit address selection
Press the Set Time buttons to select the indoor unit address for the indoor unit being registered.
• Hold down a Set Time button to scroll through the addresses quickly.
Decrement Increment
For J-series
When a remote controller group made up of a single indoor unit is registered, select the indoor unit address.
Initial Screen
See EXPLANATION OF TERMS on page 5 for
explanations of each address.