Use & Care Manual
Models SOVB - DOVB ENGLISH
29
Replacing an Oven Light
• Each oven is equipped with two halogen lights
located in the back wall of the oven.
• The lights are switched on when the door is
opened or when the oven is in a cooking cycle.
• The oven lights are not illuminated during
SELF- CLEAN.
• Each light assembly consists of a removable
lens, a light bulb as well as a light socket
housing that is fixed in place. See figure on this
page.
• Light bulb replacement is considered to be a
routine maintenance item.
To Replace a Light Bulb
1. Read WARNING on this page.
2. Turn off power at the main power supply (fuse
or breaker box).
3. In convection ovens, remove the fan cover by
unscrewing the four screws.
4. Remove the lens by unscrewing it.
5. Remove the light bulb from its socket by pulling
it.
6. Replace the bulb with a new one. Avoid
touching the bulb with fingers, as oils from
hands can damage the bulb when it becomes
hot.
7. The bulb is halogen: use one with the same
Volt and Watt (see figures on this page
).
8. Screw the lens back on.
9. Replace the fan cover if it is provided with the
oven model.
Turn power back on at the main power supply (fuse or
breaker box).
WARNING
• Make sure the oven and lights are cool and
power to the oven has been turned off before
replacing the light bulb(s). Failure to do so
could result in electrical shock or burns.
• The lenses must be in place when using the
oven.
• The lenses serve to protect the light bulb from
breaking.
• The lenses are made of glass. Handle carefully
to avoid breakage. Broken glass could cause
an injury.
To Next Page
Loading...
