14. ANNEXES - Reference Diagrams
15. WARRANTY
Image VI
PANEL
CLAMPS
CONTROLLER
CONTROLLER
Image V
Y
X
PANEL
To ensure it is properly and safely
installed, connect all leads before
putting the controller in position.
ENVIRONMENTALINFORMATION
Packaging:
The materials used in the packaging of Full Gauge products are 100% recyclable. Try to perform
disposal through specialized recyclers.
Product:
The components used in Full Gauge controllers can be recycled and reused if disassembled by
specialized companies.
Disposal:
Do not incinerate or dispose the controllers that have reached the end of their service as household
garbage. Observe the laws in your area regarding disposal of electronic waste. If in doubt, please
contact Full Gauge Controls
WARRANTY - FULL GAUGE CONTROLS
Products manufactured by Full Gauge Controls, as of May 2005, have a two (02) year warranty,
as of the date of the consigned sale, as stated on the invoice. They are guaranteed against
manufacturing defects that make them unsuitable or inadequate for their intended use.
EXCEPTIONS TO WARRANTY
The Warranty does not cover expenses incurred for freight and/or insurance when sending
products with signs of defect or faulty functioning to an authorized provider of technical support
services. The following events are not covered either: natural wear and tear of parts; external
damage caused by falls or inadequate packaging of products
LOSS OF WARRANTY
Products will automatically lose its warranty in the following cases:
- The instructions for assembly and use found in the technical description and installation
procedures in Standard IEC60364 are not obeyed;
- The product is submitted to conditions beyond the limits specified in its technical description;
- The product is violated or repaired by any person not a member of the technical team of Full
Gauge Controls;
- Damage has been caused by a fall, blow and/or impact, infiltration of water, overload and/or
atmospheric discharge.
USE OF WARRANTY
To make use of the warranty, customers must send the properly packaged product to Full Gauge
Controls together with the invoice or receipt for the corresponding purchase. As much information as
possible in relation to the issue detected must be sent to facilitate analysis, testing and execution of
the service
These procedures and any maintenance of the product may only be provided by Full Gauge
Controls Technical Support services in the company's headquarters at Rua Júlio de Castilhos, 250 -
CEP 92120-030 - Canoas - Rio Grande do Sul – Brasil
Rev. 03
Copyright 2023 Full Gauge Controls All rights reserved
To Previous Page
Loading...
