RetinaEngrave v3.0 Software
Technical Support is available from 8am to 5pm (PST) M - F at support@fslaser.com.
SECTION VI. SOFTWARE
Using RetinaEngrave v3.0 Software
In this section you will be introduced to the major interface features of RetinaEngrave
v3.0.
Figure 6.1
Technical Support is available 8am-5pm PST. Monday - Friday
support@fslaser.com • 702-802-3103
47
Editor Network
Settings (B)
Save: Save project.
Undo: Reverse your last action.
Redo: Reverse your last undo.
Muse Control (q)
Capture Workspace: Takes images of workspace
Clear Last Workspace Capture: Clears previous workspace image.
Estimate Job Time: Amount of time the job will take.
Preview Contour of All Objects: Shows laser tracing of job.
Show Bounding Perimeter of all Objects: Shows the space the job will occupy.
Run Job: Start Engraving
To Next Page
Loading...