E PressESCinordertoreturntothenormaldisplayduringanongoingcall. Ifyouconfirmyour
entrybypressingOKinsteadoftheESC,thepermanentlysetvalueisoverwrittenbythenewly
setone.
Call waiting
Ifthefunctioncallwaiting(seepage68)isenabledonyourtelephoneyoucansetthevolumeofthecallwait
-
ing signal. You can also select whether a waiting call is signaled only once, or several times.
Begin as follows:
a
Mss
Acoustic Call wait.
s Thecheckmarknextto»repeat«indicates
thatawaitingcallwilbesignaledrepeatedly.
If you press the softkey again, a waitingcall is
signaled only once. The check mark next to
»repeat« is deleted.
Call wait. tone
Volume
repeat˜
s Pressthe»Volume«softkey.
<>
O
Usethearrow buttons tosetthevolumeof the
callwaitingsignal. Thebarinthedisplayindi-
cates the current status.
Confirm your entry with OK.
Call wait. tone {}
vol.
- ©©©−- +
¬¬¬¬¬¬¬¬¬¬¬¬¬¬¬¬¬¬¬¬¬¬¬¬¬¬
Acknowledgement signals
With your ISDN system telephone you can select whetherthe acknowledgement signals are always active,
never active or onlyactive when an incorrectentry ismade. The defaultsetting has the acknowledgement
signal always active.
Begin as follows:
a
Mss
Acoustic Ack. tones
A check mark displayed next to the individual softkeys indicates the current status.
s Press the softkey for the desired function:
»No«: Acknowledgement tones always off
»ok«: Acknowledgement signal always ac
-
tive.
Configuring and setting up the system telephone
61
To Next Page
Loading...
Need help?
General
