Use with a PABX
a
Ms s
t
O>s s
Configu
-
ration
Service
Telephone
PIN
Swiss_
Var
ETSI
Call waiting
If,duringanongoingcall,asecondcallcomesinforyou,thesecondcallissignaledwhen»Callwait.protect.
on« is set. A caller will hear the busy signal, when you have set your telephone to »Call waiting off«.
Awaitingcall isindicatedbya briefacousticsignalin thespeakerandalso displayed. You cansetthe volu
-
meofthecallwaitingsignalandselectwhetherawaitingcallistobesignaledonlyonetime,orseveraltimes
(see page 61).
Whenthefunction»Silentsignalling«isactivated, callsignallingiscarriedoutasdescribedforthisfeature.
If you are usingthe hands-free option foran activeconnection, waitingcalls will only be signaled optically
in the display.
The following entries are possible for the call waiting feature:
Begin as follows:
a
Mss
Setting Call wait.
s Press the appropriate softkey below the desi-
redcallwaitingtype.Thecheckmarknexttoa
softkey indicates which setting is currently
activated for selection in the first line. When
there are various settings possible, first select
the variant frm the first line and then the
function from the lower lines. Repeat these
steps until all variants are set.
Call waiting
enable?
--internal=external--
No
ok
OK,extended
s internal, external,
internal = external
You can select the settings to be used for call waiting; internal only, ex
-
ternal only, or internal and external.
s No:
Withanongoingconnection or whileaconnectionis being established,
no further calls will be signaled.
s ok:
line Call waiting from only one subscriber is possible when:\line Only
one or two active connections and nocall waiting connection is present
at your phone.
s OK, extended:
Up to 4 simultaneous connections are possible on your telephone.
For example, two furthercalls canalso be signaled by call waitingwhile
two other calls are already in progress.
Settings
68
To Next Page
Loading...
Need help?
General
