5
IMPORTANT SAFETY INSTRUCTIONS
z Clean only with a dry cloth.
z Do not block any ventilation openings. Install in
accordance with the manufacturer’s instructions.
z Do not install near any heat sources such as radiators,
heat registers, stoves, or other apparatus (including
amplifiers) that produce heat.
WARNING: This equipment has been tested and found
to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against
harmful interference in a residential installation. This
equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful
interference to radio communications. However, there
is no guarantee that interference will not occur in a
particular installation. If this equipment does cause
harmful interference to radio or television reception,
which can be determined by turning the equipment
off and on, the user is encouraged to try to correct the
interference by one or more of the following meas-
ures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and
receiver.
- Connect the equipment to an outlet on a circuit
different from that to which the receiver is
connected.
- Consult the dealer or an experienced radio/TV
technician for help.
CAUTION: Changes or modifications not expressly
approved by the party responsible for compliance
with the FCC Rules could void the user’s authority to
operate this equipment.
z Do not press strongly upon the panel with a hand or
a sharp object such as a nail, pencil or pen, or make a
scratch on it.
z When moving TV set, turn off the power and unplug
any connecting cables. At least two people should
move the larger screen TVs to avoid personal injury
and damage to the TV.
z Place the TV somewhere away from direct sunlight.
z If a fixed image displays on the TV screen for a long
period of time, it maybe imprinted and become a per-
manent disfigurement on the screen. This is image
burn or burn-in and not covered by the warranty.
-If the aspect ratio of the TV is set to 4:3 for a long
period of time, image burn may occur on the letter-
boxed area of the screen.
Avoid displaying a fixed image on the TV screen for a
long period of time (2 or more hours for LCD, 1 or
more hours for the Plasma TV) to prevent image burn.
z The panel is a high technology product with resolu-
tion of several million pixels. In very few cases, you
could see fine dots on the screen while you’re viewing
the TV. Those dots are deactivated pixels and do not
affect the performance and reliability of the TV.
z Do not install the LCD Panel near electronic equip-
ment that produces electromagnetic waves. Some
equipment placed too close to this unit may cause
interference.
To Next Page
Loading...
