4. AIS OPERATION
4-2
3. Use the Cursorpad (S or T) to select [Display] and press the ENTER key.
AIS-Display options
4. Use the Cursorpad (S or T) to select [Off] or [On] then press the ENTER key.
5. Press the MENU key to close the menu.
4.3 AIS Symbols
When the AIS is turned on, AIS targets are displayed with AIS symbol as below.
AIS symbols
Note: The AIS symbols are momentarily erased after the screen is redrawn when the
heading is changed on the head-up mode.
4.4 Activating, Sleeping Targets
When you change a sleeping target to an activated target, a vector shows the course
and speed of that target. You can easily judge the target movement by the vector.
Activated target
Sleeping
target
Activated
target
Dangerous
target
Lost target Target selected
for data display
Heading line
SOG (Speed Over Ground) and
COG (Course over Ground) vector
(If there is no heading data,
the line points in direction of COG.)
ROT
(Rate of Turn)
To Next Page
Loading...
