6–4
6.3 Demo Display
The demo display provides simulated opera-
tion of this unit. Own ship tracks, at the speed
selected, a figure eight course, starting from
position entered. All controls are operative;
you may change course, enter marks, etc.
1) While pressing and holding down [NU/CU
ENT], turn on the power. After the test re-
sults appear, the Simulation Mode menu
appears.
Figure 6-6 Simulation mode menu
2) Key in latitude of initial position.
3) If necessary, press [
] to switch from
north latitude to south latitude or vice
versa.
4) Key in longitude.
5) If necessary, press [ ] to switch from east
longitude to west longitude or vice versa.
6) Press ▼ key.
7) Key in speed.
8) Press the [NU/CU ENT] key to start the
simulation mode.
The icon
appears in the plotter 1, 2,
and highway display. All controls are op-
erative.
Note: The return to the normal mode, turn off
the power and then turn it on while pressing
and holding down [NU/CU ENT] key.
Note: When the memory is cleared while in
the demonstration mode, the equipment starts
up in the normal mode.
_ _°
DEMO SETTING
ENT: Enter
: Column
: Cursor
_ _._ _ _' N _ _ _°_ _._ _ _' W
BASE POSITION
SPEED
00.00kt
: N/S, E/W
To Next Page
Loading...
