Furuno CH-270 - Transceiver Unit; Wiring Inside the Transceiver Unit

32
2.2 Transceiver Unit
2.2.1 Wiring inside the transceiver unit
Detach the cover of the transceiver unit and connect cables as shown in the figure below.
Remove the cover of the power terminal board to access connectors on that board.
06S4086
Hull Unit
CH-181 or
CH-184
Display Unit
MU-100C
or
Interface Unit
IF-8000
Motion
Sensor
MS-100
or
Clinometer
BS-704
DPYCYS-1.5
(or equivalent)
Ship’s Mains
12-32 VDC
06P0241
06P0258
06P0242
SPEAKER
TRX
MOTION SENSOR
EARTH
12-32VDC
DATA/VIDEO OUT
*1)
*2)
J3
External KP
External Speaker
SC-05WR
To ship’s
ground
-+
TB1
6P NH Connector
(local supply)
06P0259
J2
J1
*1) Lay shield in clamp
and securely tighten.
*2) Lay shield in clamp
and securely tighten.
(SHIELD COVER REMOVED)
J2
J10