1. MOUNTING
1-8
10. Attach zinc block to main shaft.
Attaching zinc block
11. Fasten the hull unit to the retraction tank.
Fastening the hull unit to the retraction tank
CAUTION
Ship's bow
Tank guide
Install zinc block as
near as possible to
the tank guide.
Zinc block
(Shaft diameter
ø
55)
The zinc block must be replaced yearly.
The junction between the transducer and
main shaft may corrode, which can result
in loss of the transducer or water leakage
inside the ship.
Orient round end to
tank guide side.
M20 Nut
M20 Spring washer
M20 Flat washer
Gasket
Raise/lower
drive assembly
Orient the raise/lower drive as
shown above to reduce shock and
vibration (caused by pitching and
rolling) at the assembly.
M20×80,
8 pcs.
Bow
45°
To Next Page
Loading...
