Furuno CSH-8LMARK-2 - 2.5 Synchronizing Transmission with Other Equipment

2. WIRING
2-13
CIF output sentence
Gyrocompass
Heading data from a gyrocompass can be inputted in AD-10 format via AD-100. For
details, see the operator’s manual for AD-100.
Echo sounder
Echo sounder data can be input from an echo sounder using the E/S interface VI-
1100A. For details, see the installation materials for VI-1100A.
Speed log
Log pulse (contact signal) can be input.
2.5 Synchronizing Transmission with Other Equip-
ment
2.5.1 Synchronizing transmission with another CSH-8L
When two CSH-8L are installed, connect them as shown below. This will synchronize
the transmission of the No. 2 sonar with that of the No.1 sonar.
Wiring
Connecting two CSH-8L
56 Water current, single layer
76 Water current, multi- layers
Data No. Information
5: Target position (L/L)
Data No. Information
5
6
1
2
J11
J11
1st sonar 2nd sonar
Processor unit Processor unit
Twisted pair
cable
(Local supply)
MAIN Board
10P7049A
MAIN Board
10P7049A
NH8P
(Local
supply)
NH8P
(Local
supply)
INT KP-H
INT KP-C
EXT KP-H
EXT KP-C