2. WIRING
2-8
2.4 Processor Unit
2.4.1 Wiring with transceiver unit
Attach a 38P connector to the end of the cable connected to the processor unit. Plug
in this connector to CN-A1 on the MAIN Board.
Construction of cable between processor and transceiver units
Fabricating cable between processor and transceiver units
Remove the anti corrosive sheath, armor and vinyl sheath as shown below.
Fabrication of cable between processor and transceiver units
Connecting contact pins
A special crimping tool is necessary for connection of wires to the contact pins of the
38P connector. In addition, a pin extractor should be used to remove the contact pin
from the connector housing.
Twisted pair wire
Binding tape
Armor
Vinyl sheath
Braided shield
Anti-corrosive sheath
Sheath
(5 colors)
Dot mark
No. : 1 to 4
Color : Black or Red
L
45
40
Vinyl tape
Fold back shield
onto the armor
Core
Anticorrosive
sheath
Armor
Vinyl Sheath
Shield
3.5
Crimping tool
Pin extractor
To Next Page
Loading...
