Furuno CSH-8LMARK-2 - Page 35

2. WIRING
2-9
How to use the crimping tool
1. Strip the vinyl sheath of the wire to expose the core by 3.5 mm.
2. Hold the crimping tool horizontally and insert the contact pin with its slit facing
downward into the crimp hole on the crimping tool.
3. Insert the wire onto the contact pin and squeeze the handle until the ratchet re-
leases.
(Place wire deep enough into the contact pin so that its end comes contact with
the stopper plate of the crimping tool.)
4. With crimping completed, pull the wire while holding the contact pin to make sure
that it is fastened tightly.
How to insert contact pin
Inserting contact pin into connector housing
Insert wires fitted with contact pins into the connector housing referring to the drawing
below or the interconnection diagram at the back of this manual.
Inserting contact pin into connector housing
BRN
B1
BRN
R1
YEL
B1
YEL
R1
GRN
B1
GRY
B1
WHT
B1
BRN
B2
BRN
B4
GRN
R1
GRY
R1
WHT
R1
BRN
R2
YEL
B2
YEL
R2
GRN
B2
GRN
R2
GRY
B2
WHT
R2
GRY
R2
WHT
B2
BRN
B3
BRN
R3
YEL
B3
YEL
R3
GRN
B3
GRY
B3
WHT
B3
BRN
R4
YEL
B4
GRN
R3
GRY
R3
WHT
R3
GRY
B4
YEL
R4
GRN
R4
B4
GRN
GRY
R4
T
T
S
S
R
R
P
P
J
J
K
K
L
L
M
M
N
N
D
D
E
E
F
F
H
H
A
A
B
B
C
C
Z
X
Y
VW
RS
T
U
L
M
N
P
E
F
H
J
K
A
B
C
D
Note: 1. Wire differentiation
2. BRN and GRN show the following colors.
BRN: Light brown
GRN: Light green
3. Cover plate is not fitted to the connector.
Number of dot mark (s) (1 to 4)
Dot mark color (B: Black, R: Red)
Sheath color
BRN
B 1