2. WIRING
2-10
How to use pin extractor
If a contact pin is inserted into an incorrect hole on the connector body, remove it with
the pin extractor.
1. Push the pin extractor into the pin hole from the side opposite to the pin inserting
side.
2. Push in the head of the pin extractor. The retaking spring comes free and the con-
tact pin can be removed.
How to extract contact pin
Fixing the cable
Set shield and armor section in cable clamp and tighten cable clamp.
How to set cable in cable clamp
Other connections
Shield and armor
Cable clamp
Anticorrosive sheath
Remote
controller
NMEA1
CIF1
NMEA2
CIF2
E/S
Gyro
(AD converter)
Speed log/current indicator
External KP
Transceiver unit
Ground
Speaker
Control unit
Monitor 2
Monitor 1
To Next Page
Loading...
