Furuno DFF-3D - Page 33

3. INITIAL SETTINGS
3-7
Motion Sensor menu
Select [Transducer Setup] on the [Multibeam Sonar] menu to show the [Motion Sen-
sor] menu (below the [Transducer Setup] menu).
If the center of gravity is not known, see the drawing below.
Note: The location of the center of gravity may be different than as shown in the fig-
ures above, depending on hull shape, engine position and the installation status of
other equipment.
Menu item Description
Options
(setting range)
[Motion Sensor
Source]
Select the sensor connected to you NavNet TZtouch2 unit. [SC], [Internal],
[OFF]
[Motion Sensor
Pos. Bow/Stern]
Set the distance from the transducer to the motion sensor
in the bow-stern direction. For the stern side, set a positive
value.
Note: This menu appears if the motion sensor source is
selected to [SC].
-100 to 100.0 (m)
GCTD
GC
TD
Up dir.: "+"
Stern dir.: "+"
Port dir.: "+"
Top view
Starboard view
SC
SC
GC: Gravity Center, TD: Transducer, SC: Satellite Compass
GC
GC
W
W/2
Top view
Starboard view
Engine
H
H/2
L/3
L
GC: Gravity Center
GC: Gravity Center, TD: Transducer
Engine