3. INITIAL SETTINGS
3-8
Sync (time lag) setting
• If the equipment is connected as shown below, no adjustment to the time lag set-
tings is necessary.
[Motion Sensor
Pos. Up/Down]
Set the distance from the transducer to the motion sensor
in the up/down (vertical) direction. Use a "+" value for up-
ward direction.
Note: This menu appears if the motion sensor source is
selected to [SC].
-100 to 100.0 (m)
[Motion Sensor
Pos. Port/Star-
board]
Set the distance from the transducer to the motion sensor
in the port-starboard direction. For port location, set a pos-
itive value.
Note: This menu appears if the motion sensor source is
selected to [SC].
-100 to 100.0 (m)
[GPS Sensor
Pos. Bow/Stern]
Set the distance from the transducer to the GPS sensor in
the bow-stern direction. For stern location, set a positive
value.
-100 to 100.0 (m)
[GPS Sensor
Pos. Up/Down]
Set the distance from the transducer to the GPS sensor in
the up/down (vertical) direction. Use a "+" value for upward
direction.
-100 to 100.0 (m)
[GPS Sensor
Pos. Port/Star-
board]
Set the distance from the transducer to the GPS sensor in
the port-starboard direction. For port location, set a posi-
tive value.
-100 to 100.0 (m)
[Roll Sensor Off-
set]
Set the roll offset to use with the internal motion sensor.
Note: This menu appears if the motion sensor source is
selected to [Internal].
-45.0 to 45.0
[Pitch Sensor
Offset]
Set the pitch offset to use with the internal motion sensor.
Note: This menu appears if the motion sensor source is
selected to [Internal].
-45.0 to 45.0
[Motion Sensor
Time Lag (in ms)]
Set the time lag to use with the external motion sensor.
Note: This menu appears if the motion sensor source is
selected to [SC].
0 to 400
[Heading Sensor
Time Lag (in ms)]
Set the time lag for the data received from the position sen-
sor.
0 to 3500
[Position Sensor
Time Lag (in ms)]
Set the time lag for the data received from the position sen-
sor.
0 to 3500
Menu item Description
Options
(setting range)
Heading sensor time lag: 20 msec
DFF-3D
SC-30
------------------
Ethernet
CAN bus
------------
Motion sensor time lag: 20 msec
Position sensor time lag: 20 msec
Multi Function
Display
To Next Page
Loading...
