2. WIRING
2-6
2.3 How to Adjust the Analog Indicator
If it is necessary to adjust the offset or gain of the analog indicator or analog output,
output dummy speed from the demo mode then adjust the applicable potentiometer
on the MAIN board in the DS-610.
How to adjust the analog indicator
1. Set 0 kn for test speed in the demo mode, then adjust the offset of the analog in-
dicator.
2. Set 15 kn or 20 kn for test speed in the demo mode, then adjust the gain of the
analog indicator.
Note: Do the test for the gain adjustment with the ship’s cruising speed.
The specifications of voltage and current for analog indicator
1) ANA_DISP1 offset adjustment: R180 (Rotate clockwise to offset in the AST direction)
2) ANA_DISP1 gain adjustment: R181 (Rotate clockwise to decrease the gain)
3) ANA_DISP2 offset adjustment: R169 (Rotate clockwise to offset in the AST direction)
4) ANA_DISP2 gain adjustment: R181 (Rotate clockwise to decrease the gain)
5) ANA_V offset adjustment: R198 (Rotate clockwise to increase the offset value)
6) ANA_V gain adjustment: R190 (Rotate clockwise to increase the gain)
7) ANA_C offset adjustment: R212 (Rotate clockwise to increase the offset value)
8) ANA_C gain adjustment: R217 (Rotate clockwise to increase the gain
Voltage output -10 to 30 kn: -3.33 to 10.0 V
Current output -10 to 30 kn: 4.0 to 20.0 mA (0 kn: 8.0 mA)
R198
R217
R212
R190
R181
R180
R169
R170
To Next Page
Loading...
