Furuno DS-60 - 3 Menu Settings; How to Use the [Service] Menu

3-1
3. MENU SETTINGS
After the installation is completed, set up the system from the [Service] and [System]
menus.
3.1 How to Use the [Service] Menu
1. Press and hold the DISP key, then press the PWR key to show the [Service]
menu.
Note: Do not release the DISP key until the system releases a audible beep.
[Service] menu
2. Press  or  to select a menu item, and press the ENT key to show the setting
window.
3. Press  or  to change the setting, and press the ENT key. To return to the
menu, press the MENU/ESC key.
To enter alphanumeric data; for example, [Ship’s Name], do the following:
1) A character input box appears, with the input cursor at the far-left position.
2) Press  or  to select character.
3) Press the ENT key to confirm selection.
4) Repeat step 2) and step 3) to complete the item.
You can move the input cursor with the ENT and MENU/ESC keys.
ENT: Move right.
MENU/ESC: Move left.
4. Repeat step 2 and step 3 to complete the setting.
For items to be set at the installation, see the table on next page.
5. Press the PWR key to turn the power off.
ROT RESET
Input cursor