1. INSTALLATION
1-2
2. Make four pilot holes for self-tapping screws (diameter: 5 mm) in the location in-
dicated in the illustration on "Flush Mount" on page 1-1.
3. Insert the sponge to the display unit from the rear side.
4. Set the display unit to the cutout and fasten the display unit with four self-tapping
screws (5x20).
5. Set a cosmetic cap to each fixing hole on the front panel. See page 1-3.
Desktop or table underside mount
The display unit can be mounted on a desktop or on the underside of a table using the
optional hanger. See the outline drawing for details.
Hanger assembly (Type: OP26-8, Code No.: 000-016-313-00)
1. Remove the hanger mounting plate from the hanger assembly.
2. Fasten the hanger mounting plate to the display unit from the left side and right
side with four binding head screws (M5x12).
3. Make a four pilot holes for self-tapping screws (5x20) in the mounting location.
4. Fix the hanger to the mounting location with four self-tapping screws (5x20).
5. Screw knobs into the display unit loosely.
6. Set the display unit to the hanger.
7. Tighten the knobs to fasten the hanger to the display unit.
Name Type Code No. Qty
Self-tapping screw 5x20 000-171-997-10 4
Binding head screw M5x12 000-171-999-10 4
Hanger Assembly OP26-8-1 001-081-920-00 1
Screw (M5x12)
Hanger mounting
plate (left side)
To Next Page
Loading...
