AP6.3 Setting
3. Move the cursor onto “Installation Parameter” and press [SELECT] to open
“Installation Parameter”.
4. Move the pointer onto in “Sensor Parameter” list box and press [SELECT] to
show “SENSOR” list.
5. Move the cursor onto “AIS Transponder” and press [SELECT] to show “Edit
parameters-AIS transponder”.
Installation parameters
Sensor Parameters
Set parameter default Sensor Channel usage
Workstation parameters
Set Signal Workstation Mode Workstations
OK Cancel
General
Gyro 1
Gyro 2
Speedpilot
AIS Transponder
VDR
Edit parameters-AIS transponder
Connected
A- Adapter CH
Device interface
Device mode
Checksum
IEC61162-1 Transmit checksum
Char not included (IEC61162-1 or 2)
YES
4
IEC61162-2(38400 bit/s)
Allow illegal values
Used
OK
Cancel
AP6-10
To Next Page
Loading...
