2 MAINTENANCE, TROUBLESHOOTING
35
2.7 Error Messages
The FA-100 displays the following error messages to alert you to invalid data,
etc..
Error messages
Message Meaning
BATTERY ERROR! Voltage of backup battery is getting low.
BACKUP ERROR
ROM contents erased because voltage of backup
battery is too low.
ENTER MMSI Your MMSI was not found when turning on the power.
NO SEL. RENEW AGAIN
No data found for target selected (target data,
dangerous ship).
CAN’T DISPLAY OVER LAT85° Own ship’s latitude is higher than 85°.
CAN’T DISPLAY INVALID DATA Invalid own ship position.
NO MMSI
MMSI not entered when SEND MSG is set for
ADDRESS-CAST.
SYNCHRONISM CAN’T TAKEN
Slot synchronization not yet performed when you
attempted to send a message.
NO MESSAGE!
No TX message when you attempted to send a
message.
SEND FAILED! Transmission failed.
UNSUCCESSFUL!
Message sent did not reach specified station. (Not
receiving ACK.)
NO MESSAGE No TX or RX message.
OUT OF RANGE!: DRAUGHT:0-25.5 Invalid draught entered in SET SHIP DATA.
OUT OF RANGE!: YEAR Invalid year entered in SET DESTINATION.
OUT OF RANGE!: MONTH:1-12 Invalid month entered in SET DESTINATION.
OUT OF RANGE!: DAY:1-29/30/31 Invalid day entered in SET DESTINATION.
OUT OF RANGE!: HOUR:0-23 Invalid hour entered in SET DESTINATION.
OUT OF RANGE!: MINUTE:0-59 Invalid minute entered in SET DESTINATION.
OUT OF RANGE!: CREW:0-8191 Invalid crew no. entered in SET CREW&TYPE.
OUT OF RANGE!: CPA:0-6.00 Invalid CPA range entered.
OUT OF RANGE!: TCPA:0-60 Invalid TCPA entered.
OUT OF RANGE!: CH-A:IT
DOESN’T EXIST
Invalid CH-NO. A entered on the CHANNEL EDIT
sub-menu.
OUT OF RANGE!: CH-A:IT
DOESN’T EXIST
Invalid CH-NO. A entered on the CHANNEL EDIT
sub-menu.
OUT OF RANGE!: ZONE:1-8
Invalid ZONE entered on the CHANNEL EDIT
sub-menu.
ERROR REGIST Duplicate data in overlapping sea areas.
OUT OF RANGE!: ROT CYCLE:1-10 Invalid ROT entered in SET I/O menu.
To Next Page
Loading...
